Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão o guia que inclui este passo.

Inglês
Japonês
Passo 4
Remove the three 8.4 mm #1 Phillips screws securing the heat sink to the logic board. Don't lose the springs held under each of the screws.
  • Remove the three 8.4 mm #1 Phillips screws securing the heat sink to the logic board.

  • Don't lose the springs held under each of the screws.

  • Carefully remove the heat sink from the processor.

  • If the heat sink seems to be stuck, it may be helpful to gently pry it off the processor with a plastic spudger. Be careful not to break any surface mount components on the processor while prying.

  • Be sure to clean off the old thermal paste and apply a new layer before you reinstall the heat sink. We have a guide that makes it easy.

ロジックボードにヒートシンクを固定している 8.4 mm #1プラスネジを1本外します。

各ネジの下に付けられているネジを紛失しないでください。

プロセッサからゆっくりとヒートシンクを取り出します。

ヒートシンクが動かない場合は、プラスチックのスパッジャーを使って、ゆっくりとプロセッサをこじ開けてください。プロセッサ上の表面にマウントされているコンポーネントにダメージを与えないよう丁寧に作業を進めてください。

古い放熱グリスを綺麗に拭き取り、ヒートシンクを装着する前に新しい放熱グリスを塗ってください。放熱グリスの塗布方法のガイドも参照してください。

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.