Ir para o conteúdo principal

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão todos os 2 guias que incluem este passo.

Inglês
Japonês
Passo 6
Use a flathead screwdriver to release the two clips located on the back half of the drive assembly. The final clip doesn't need to be released; the top half of the drive assembly will slide away from the lower half. Finish removing the top half of the drive assembly from the base.
  • Use a flathead screwdriver to release the two clips located on the back half of the drive assembly.

  • The final clip doesn't need to be released; the top half of the drive assembly will slide away from the lower half.

  • Finish removing the top half of the drive assembly from the base.

  • Be careful not to detach the red wire or the white ribbon cable still attached.

マイナスドライバーを使って、ドライブアセンブリの裏半分に付いている2つのクリップを外します。

最後のクリップは外す必要はありません。ドライブアセンブリの上部半分は下側半分からスライドして外れます。

ベース部分からドライブアセンブリの上部半分を外します。

赤いワイヤもしくは白いリボンケーブルを外さないようにご注意ください。

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.