Ir para o conteúdo principal

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão todos os 2 guias que incluem este passo.

Inglês
Japonês
Passo 2
Remove the blue wire by gently pulling. Disconnect the Brown cable. This is done by gently pulling the black tab away from the white plastic. This will loosen the tension on the brown cable allowing it to gently be slid away from the tab. Shown in the third picture, remove the 4 Phillips #1 screws connecting the circuit board to the optical drive assembly.
  • Remove the blue wire by gently pulling.

  • Disconnect the Brown cable. This is done by gently pulling the black tab away from the white plastic. This will loosen the tension on the brown cable allowing it to gently be slid away from the tab.

  • Shown in the third picture, remove the 4 Phillips #1 screws connecting the circuit board to the optical drive assembly.

  • The fourth screw is located behind the screwdriver in the third picture (highlighted in the orange circle).

青いワイヤをゆくりと引き抜きます。

黒いタブを白いプラスチックからゆっくりと引き離して茶色のケーブルの張力を緩めて、タブからゆっくりと離れることができます。

3枚目の画像のように、回路基板と光学ドライブアセンブリを接続している4本の#1プラスネジを外します。

4本目のネジは、3枚目の画像のドライバの後ろにあります(オレンジ色でハイライト)

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.