Ir para o conteúdo principal

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão o guia que inclui este passo.

Inglês
Chinês
Passo 12
Clean up the glue that remains on the borders. A small microfiber with a bit of WD40 or windex can help you take all the glue off.
  • Clean up the glue that remains on the borders. A small microfiber with a bit of WD40 or windex can help you take all the glue off.

  • Be sure to not use too much WD40 or windex.

  • When cleaning out the glue, do NOT attempt to scrap glue out of the cracks between the LCD and the frame. A very small amount of force toward the center or from underneath will crack the LED.

  • Cut up two small 1mm pieces of the sticker tape and glue the buttons to the phone to keep them in place.

  • It's very important to make sure the buttons line up exactly with the picture.

清理残留在边界上的胶水。有一点WD40或该小微纤维可以帮助你把所有的胶水清理掉。

不要使用太多的WD40或清洗剂。

清洗胶水时,不要试图将胶水从LCD和框架之间的缝隙中取出。一个向中心或下方的非常小的力将使LED产生裂纹。

剪下两块1毫米宽的胶带,然后将按键粘在手机上,使它们保持在适当的位置。

确保按钮和图片完全一致是很重要的。

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.