Ir para o conteúdo principal

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão todos os 8 guias que incluem este passo.

Inglês
Japonês
Passo 20
At this point it's a good idea to test your repair, in order to make sure your iMac works properly before you seal it back up. Follow the next three steps to temporarily reconnect the display cables and boot up your iMac prior to pulling the protective film off the adhesive strips. If you've already verified that your iMac is working correctly and are ready to seal it up, skip the next step.
Test the display
  • At this point it's a good idea to test your repair, in order to make sure your iMac works properly before you seal it back up. Follow the next three steps to temporarily reconnect the display cables and boot up your iMac prior to pulling the protective film off the adhesive strips.

  • If you've already verified that your iMac is working correctly and are ready to seal it up, skip the next step.

  • Insert the display power cable into its socket on the logic board.

この時点で、修理の状況をテストして、iMacが正しく起動することを確認してから再組み立てすることをお勧めします。 接着ストリップの裏地を剥がす前に、次の3つの手順に従って、ディスプレイケーブルを一時的に再接続し、iMacを起動します。

iMacが正しく動作していることを確認し、密封する準備ができている場合は、次の手順に進んでください。

ディスプレイの電源コネクタをロジックボードのソケットに挿入します。

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.