Ir para o conteúdo principal

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão o guia que inclui este passo.

Inglês
Holandês

Traduzindo o passo 1

Passo 1
Use a Y000 driver to remove the 1.1 mm screws securing the LCD shield: Three screws on the side nearest the display cables Two more screws on the opposite side
Unscrew the LCD shield plate
  • Use a Y000 driver to remove the 1.1 mm screws securing the LCD shield:

  • Three screws on the side nearest the display cables

  • Two more screws on the opposite side

  • Press your driver firmly into the screw while turning it. If needed, you can use your spudger to brace each screw from behind, in order to apply more pressure to the screws without bending the shield.

Gebruik een Y000-schroevendraaier om de 1.1 mm schroeven die de LCD-plaat bevestigen, te verwijderen:

Drie schroeven die dichtbij de schermkabels zitten

Nog twee schroeven aan de andere kant

Duw je schroevendraaier stevig in de schroef bij het losdraaien. Indien nodig, kun je je spudger gebruiken om de schroef van achteren te ondersteunen, zodat je meer kracht op de schroef kunt zetten zonder het plaatje te verbuigen.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.