Ir para o conteúdo principal
Inglês
Holandês
Passo 2
The following three steps show how to remove and transfer the fingerprint sensor and its gasket. If your phone's fingerprint sensor and camera reside on a single rear bezel (like on the S9), you can transfer that bezel without removing the parts individually. Heat an iOpener and apply it to the fingerprint sensor for one minute.
Fingerprint sensor and gasket adhesive
  • The following three steps show how to remove and transfer the fingerprint sensor and its gasket.

  • If your phone's fingerprint sensor and camera reside on a single rear bezel (like on the S9), you can transfer that bezel without removing the parts individually.

  • Heat an iOpener and apply it to the fingerprint sensor for one minute.

  • Use an opening tool to gently pry the fingerprint sensor at the lower seam, where it contacts the back cover.

  • Do not pry at the upper seam, which is the fingerprint gasket seam.

Insira tradução aqui

Insira tradução aqui

Insira tradução aqui

Insira tradução aqui

Insira tradução aqui

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.