Ir para o conteúdo principal
Inglês
Espanhol
Passo 7
Before applying any adhesive, make sure your replacement part fits, and that all connectors will connect without putting too much stress on their cables. If it is safe to do so, power on your device and verify that everything functions correctly. If everything works, power off the device and continue. If anything does not function as expected, visit the Answers Forum for troubleshooting advice. With the device powered off, apply the correct adhesive shape for your repair.
Application and Installation
  • Before applying any adhesive, make sure your replacement part fits, and that all connectors will connect without putting too much stress on their cables. If it is safe to do so, power on your device and verify that everything functions correctly. If everything works, power off the device and continue.

  • If anything does not function as expected, visit the Answers Forum for troubleshooting advice.

  • With the device powered off, apply the correct adhesive shape for your repair.

  • Avoid applying adhesive over ribbon cables, or delicate surfaces like NFC or wireless charging coils.

  • When applying adhesive strips, make sure to apply one end first, then use a finger or the flat end of a spudger to smooth the rest of the strip as you lay it down, squeezing out any air bubbles.

  • Use a pair of tweezers to peel the backing off the adhesive.

Antes de aplicar cualquier adhesivo, asegúrate de que tu parte de repuesto encaje y que todos los conectores se conecten sin poner demasiada tensión en sus cables. Si es seguro hacerlo, enciende su dispositivo y verifica que todo funcione correctamente. Si todo funciona, apaga el dispositivo y continúa.

Si algo no funciona como se espera, visita el foro de respuestas para obtener consejos para la solución de problemas.

Con el dispositivo apagado, aplica la forma de adhesivo correcta para su reparación.

Evita aplicar adhesivo sobre cables de cinta, o superficies delicadas como NFC o bobinas de carga inalámbricas.

Cuando aplicas tiras adhesivas, asegúrate de aplicar primero un extremo, luego usa un dedo o el extremo plano de un spudger para suavizar el resto de la tira mientras la colocas, y exprime las burbujas de aire.

Usa un par de pinzas para despegar el adhesivo del adhesivo.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.