Conserte seus objetos Comunidade Loja

Este guia tem alterações mais recentes. Mudar para a última versão não verificada.

iPod Nano 5th Generation Click Wheel Replacement

Pré-requisito somente
Este guia destina-se apenas a ser usado como pré-requisito para outros guias. É incompleto por si só.

Introdução

A prerequisite for removing the logic board assembly.

O que você precisa

  1. iPod Nano 5th Generation Click Wheel Replacement, Click Wheel: passo 1, imagem 1 %32 iPod Nano 5th Generation Click Wheel Replacement, Click Wheel: passo 1, imagem 2 %32

    • Use a heat gun to soften the adhesive underneath the plastic bezel at the bottom of the iPod.

    • Use a low heat setting and do not hold the heat gun in place for too long to avoid melting the plastic bezel.

    • Use a plastic opening tool to pry the bezel from the case of the iPod and remove it.

    Editar

  2. iPod Nano 5th Generation Click Wheel Replacement: passo 2, imagem 1 %32 iPod Nano 5th Generation Click Wheel Replacement: passo 2, imagem 2 %32 iPod Nano 5th Generation Click Wheel Replacement: passo 2, imagem 3 %32

    • Unscrew three screws from the bottom of the iPod:

    • Two 4.4 mm angled Phillips screws

    • One 5.4 mm Phillips screw.

    • These screws may not come out on their own, so be sure not to lose them when removing the retainer.

    • Use a plastic opening tool to pry the metal retainer out from the bottom of the iPod and remove it.

    Editar

  4. iPod Nano 5th Generation Click Wheel Replacement: passo 3, imagem 1 %32 iPod Nano 5th Generation Click Wheel Replacement: passo 3, imagem 2 %32

    • Insert a metal spudger into the slot at the bottom of the iPod just above the dock connector.

    • Use the metal spudger to pry up the bottom edge of the click wheel.

    Editar

  5. iPod Nano 5th Generation Click Wheel Replacement: passo 4, imagem 1 %32 iPod Nano 5th Generation Click Wheel Replacement: passo 4, imagem 2 %32

    • Place a guitar pick between the click wheel and the case of the Nano and remove the metal spudger.

    • Pry up the edges of the click wheel with the guitar pick until the click wheel comes free from the case.

    • Do not try to completely remove the click wheel yet, as it is still held in place by a ribbon cable.

    Editar

  6. iPod Nano 5th Generation Click Wheel Replacement: passo 5, imagem 1 %32 iPod Nano 5th Generation Click Wheel Replacement: passo 5, imagem 2 %32

    • Lift the click wheel out of the way with one hand and use a plastic opening tool to pry the click wheel ribbon cable connector off its socket on the logic board.

    • Remove the click wheel.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

com 6 outros contribuidores

Matthew Newsom

Membro desde: 01/05/10

39.500 Reputação

Autoria de 67 guias

Emblemas: 47

+44 outros emblemas

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 1,164