Conserte seus objetos

Direito de executar reparos

Peças e ferramentas

iPhone 7 Plus Display Assembly Replacement

Escrito Por: Paige Reisman (e 2 outros contribuidores)
  • Comentários: 13
  • Favoritos: 9
  • Execuções: 10

Dificuldade

Moderado

Passos

4

Tempo necessário

30 minutos - 1 hora

Partes

1

Sinalizadores

1

Prerequisite Only

Pré-requisito somente

Por favor, note que este guia é apenas um pré-requisito para outros guias.

Introdução

Prereq only for detaching the display assembly.

  1. Make sure the battery is disconnected before you disconnect or reconnect the cables in this step. Use the flat end of a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board. To re-attach press connectors, press down on one end until it clicks into place, then repeat on the other end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.

    • Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.

    • Use the flat end of a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board.

    • To re-attach press connectors, press down on one end until it clicks into place, then repeat on the other end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.

    • If you have a blank screen, white lines on the display, or partial or complete lack of touch response after reassembling your phone, try disconnecting and carefully reconnecting both of these cables and make sure they are fully seated.

    Editar

  2. Remove the three tri-point Y000 screws securing the bracket over the front panel sensor assembly connector: One 1.3 mm screw Two 1.0 mm screws

    • Remove the three tri-point Y000 screws securing the bracket over the front panel sensor assembly connector:

    • One 1.3 mm screw

    • Two 1.0 mm screws

    • Remove the bracket.

    Editar

  3. Telas LCD de reposição iPhone (com ferramentas)

    A opção econômica, coberta por nossa garantia vitalícia.

    Confira os kits

    Telas LCD de reposição iPhone (com ferramentas)

    Reduza os custos de reparo, não a qualidade.

    Confira os kits

  4. Disconnect the front panel sensor assembly connector from its socket on the logic board. This press connector should also be reconnected one end at a time to minimize the risk of bending.

    • Disconnect the front panel sensor assembly connector from its socket on the logic board.

    • This press connector should also be reconnected one end at a time to minimize the risk of bending.

    Editar

  5. Remove the display assembly.
    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

10 outras pessoas concluíram este guia.

Autor

com 2 outros contribuidores

Paige Reisman

Membro desde: 07-04-2014

18.851 Reputação

15 Guias de autoria

Emblemas: 38

+35 outros emblemas

0 comentários

Adicionar um comentário

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 12

Duração total: 5,136