Ir para o conteúdo principal

Este guia tem alterações mais recentes. Mudar para a última versão não verificada.

iPhone 6 Plus Antenna Assembly Replacement

Pré-requisito somente
Este guia destina-se apenas a ser usado como pré-requisito para outros guias. É incompleto por si só.

O que você precisa

  1. iPhone 6 Plus Antenna Assembly Replacement, Antenna Assembly: passo 1, imagem 1 %32
    • Remove the following screws securing the antenna bracket to the rear case:

    • One 1.5 mm Phillips #00 screw

    • One 2.8 mm Phillips #00 screw

  2. iPhone 6 Plus Antenna Assembly Replacement: passo 2, imagem 1 %32
    • Grasp the antenna bracket with a pair of tweezers and lift it off the iPhone.

  3. iPhone 6 Plus Antenna Assembly Replacement: passo 3, imagem 1 %32
    • Carefully pry the antenna connector up off the logic board with a plastic opening tool.

  4. iPhone 6 Plus Antenna Assembly Replacement: passo 4, imagem 1 %32 iPhone 6 Plus Antenna Assembly Replacement: passo 4, imagem 2 %32
    • Grasp the antenna connector with a pair of tweezers and gently lift it from its retaining clip on the logic board.

  5. iPhone 6 Plus Antenna Assembly Replacement: passo 5, imagem 1 %32 iPhone 6 Plus Antenna Assembly Replacement: passo 5, imagem 2 %32
    • The two connectors may be coupled by a single adhesive tab. If this is the case, then they may detach as a pair.

    • Disconnect the power button cable and audio control cable connectors from their respective sockets on the logic board.

  6. iPhone 6 Plus Antenna Assembly Replacement: passo 6, imagem 1 %32
    • Remove the following screws securing the top cellular antenna to the rear case:

    • One 2.8 mm Phillips #00 screw

    • Two 1.6 mm Phillips #00 screws

  7. iPhone 6 Plus Antenna Assembly Replacement: passo 7, imagem 1 %32 iPhone 6 Plus Antenna Assembly Replacement: passo 7, imagem 2 %32
    • Use a pair of tweezers to grasp and remove the top cellular antenna out of the iPhone.

    • During reassembly, make sure to place the small washer in the top left corner of the antenna assembly.

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas executaram este guia.

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 1,048