Esta versão pode conter edições incorretas. Mude para o último instantâneo verificado.
O que você precisa
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Insert a SIM card eject tool or paper clip into the hole next to the headphone jack.
-
Press down on the paper clip until the SIM card tray pops out.
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Grasp the SIM card tray and slide it out of the iPhone.
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Insert a metal spudger into the slot between the dock connector and the antenna cover. Gently pry up near the two tabs to create a small gap between the antenna cover and the silver front bezel.
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Insert an iPod opening tool in the gap between the antenna cover and the front bezel. The wedge of the tool should be pointing towards the antenna cover. Slide the tool around the corner and up until you reach the metal backing.
-
Repeat the same procedure on the other side of the dock connector.
-
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Grasp the antenna cover on either side and slide it up and away from the iPhone. This requires some force. If it does not come free, ensure that the antenna cover is lifted up enough to free the catches.
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Remove the three Phillips #00 screws securing the rear panel to the iPhone.
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
The small square hole is the location to insert the dental pick in the next step.
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Start removing the rear panel on the side with the buttons.
-
Slide the dental pick completely into the square hole. You may need to wiggle the tool and apply a good amount of force to get it to go all the way.
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Pry up the rear panel by pulling the dental pick counterclockwise in a quick motion. Apply force perpendicular to the plane of the display assembly. You may be afraid to go fast, but going slowly is more likely to bend the case.
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Use a spudger to free the rear panel from the iPhone along the corner and top.
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Repeat the same procedure on the other side of the iPhone. Slide the dental pick completely into the square hole. You may need to wiggle the tool and apply a good amount of force to get it to go all the way.
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Pry up the rear panel by pulling the dental pick clockwise in a quick motion. Apply force perpendicular to the plane of the display assembly. You may be afraid to go fast, but going slowly is more likely to bend the case.
-
The rear panel is still attached to the iPhone by the headphone jack cable, so don't entirely remove the rear panel from the iPhone just yet.
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Use a spudger to disconnect the headphone jack cable from the logic board.
-
Cancelar: não concluí este guia.
51 outras pessoas executaram este guia.