Fix Your Stuff Community Store

iPad mini 4 LTE Battery Connector Replacement

Written By: Evan Noronha (and 2 other contributors)
  • Comments: 5
  • Favorites: 0

Difficulty

Difficult

Steps

3

Time Required

Suggest a time??

Sections

1

Flags

1

Prerequisite Only

Prerequisite Only

Please note that this guide is only a prerequisite for other guides.

Introduction

Prerequisite guide for disconnecting the battery before performing any repair.

Tools

Parts

No parts specified.

  1. To avoid stressing any cables, hold the display assembly perpendicular to the body of the iPad until it is disconnected.

    • To avoid stressing any cables, hold the display assembly perpendicular to the body of the iPad until it is disconnected.

    • Remove the four 1.2 mm Phillips screws over the battery/display connector bracket.

    Edit

  3. Remove the battery/display cable bracket.

    • Remove the battery/display cable bracket.

    Edit

  4. When disconnecting any press connectors from the logic board, be sure to lift the connector straight up to avoid ripping the socket off the board. Use the flat tip of a spudger to disconnect the battery connector from its socket on the logic board.

    • When disconnecting any press connectors from the logic board, be sure to lift the connector straight up to avoid ripping the socket off the board.

    • Use the flat tip of a spudger to disconnect the battery connector from its socket on the logic board.

    • Bend the battery connector ribbon cable up slightly to prevent it from making contact and powering on the iPad.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

with 2 other contributors

Evan Noronha

Member since: 05/02/2015

213.074 Reputation

178 Guides authored

Badges: 49

+46 more badges

Team

The Home Depot Member of The Home Depot

Community

8.928 Members

1.024 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 2

All Time: 159