Ir para o conteúdo principal

Introdução

prereq for everything upper case

  1. Remove the following screws securing the upper component cable bracket:
    • Remove the following screws securing the upper component cable bracket:

    • Two 2.0 mm Phillips screws

    • Three 1.4 mm Phillips screws

  2. Use tweezers to start peeling back the tape securing the upper component cable bracket. Use tweezers to start peeling back the tape securing the upper component cable bracket.
    • Use tweezers to start peeling back the tape securing the upper component cable bracket.

  3. Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall. Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall. Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall.
    • Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Andrew Optimus Goldheart

Membro desde: 17/10/2009

474.296 Reputação

410 Guias de autoria

Equipe

iFixit Membro de iFixit

Community

137 Membros

16.428 Guias de autoria

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 52