Conserte seus objetos Comunidade Loja

iPad 2 GSM Headphone Jack Assembly Replacement

Pré-requisito somente
Este guia destina-se apenas a ser usado como pré-requisito para outros guias. É incompleto por si só.

Introdução

Prerequisite only.

O que você precisa

  1. iPad 2 GSM Headphone Jack Assembly Replacement, Headphone Jack Assembly: passo 1, imagem 1 %32 iPad 2 GSM Headphone Jack Assembly Replacement, Headphone Jack Assembly: passo 1, imagem 2 %32 iPad 2 GSM Headphone Jack Assembly Replacement, Headphone Jack Assembly: passo 1, imagem 3 %32

    • Use the flat end of a plastic opening tool to flip up the retaining flap on the headphone jack and front-facing camera ribbon cable ZIF socket.

    • Be sure you are prying up on the hinged retaining flap, not the socket itself.

    • Run a plastic opening tool underneath the headphone jack and front-facing camera cable to free it from the adhesive attaching the cable to the rear panel.

    • Pull the headphone jack and front-facing camera ribbon cable straight out of its socket on the logic board.

    Editar

  2. iPad 2 GSM Headphone Jack Assembly Replacement: passo 2, imagem 1 %32

    • Remove the three 2 mm Phillips screws securing the SIM slot to the rear panel.

    Editar

  3. iPad 2 GSM Headphone Jack Assembly Replacement: passo 3, imagem 1 %32

    • Remove the two 2.9 mm Phillips screws securing the headphone jack to the rear panel.

    Editar

  5. iPad 2 GSM Headphone Jack Assembly Replacement: passo 4, imagem 1 %32

    • Use a plastic opening tool to help pull the headphone jack away from its recess in the top edge of the iPad.

    • Don't try to remove the assembly just yet.

    Editar

  6. iPad 2 GSM Headphone Jack Assembly Replacement: passo 5, imagem 1 %32

    • Carefully peel the front camera and microphone cables off the rear panel.

    Editar

  7. iPad 2 GSM Headphone Jack Assembly Replacement: passo 6, imagem 1 %32 iPad 2 GSM Headphone Jack Assembly Replacement: passo 6, imagem 2 %32

    • Carefully remove the strip of tape covering the front camera cable connector.

    • Use the edge of a plastic opening tool to disconnect the front camera cable from the headphone jack cable.

    Editar

  8. iPad 2 GSM Headphone Jack Assembly Replacement: passo 7, imagem 1 %32

    • Carefully peel the front camera cable off the bottom ribbon cable attached to the headphone jack.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

0 comentários

Comentar

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 6

Ao todo: 827