Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Peças

Nenhum componente especificado.

  1. Disconnect the hard drive thermal sensor from the top edge of the logic board.
    • Disconnect the hard drive thermal sensor from the top edge of the logic board.

    • Pull the connector parallel to the face of the logic board.

  2. Remove the two 9.2 mm T10 Torx screws securing the hard drive bracket to the rear case.
    • Remove the two 9.2 mm T10 Torx screws securing the hard drive bracket to the rear case.

  3. Lift the hard drive from its left edge enough to clear the inverter and pull it toward the left edge of your iMac to unseat the mounting pins from the chassis.
    • Lift the hard drive from its left edge enough to clear the inverter and pull it toward the left edge of your iMac to unseat the mounting pins from the chassis.

    • During installation, do not push the rubber grommets through the chassis with the hard drive mounting pins as retrieving them will require removing the logic board.

  4. Pull both the SATA power and data cable connectors away from the hard drive. Be careful when de-routing the hard drive thermal sensor cable from under the heat sink framework.
    • Pull both the SATA power and data cable connectors away from the hard drive.

    • Be careful when de-routing the hard drive thermal sensor cable from under the heat sink framework.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 1,265