Ir para o conteúdo principal

Este guia tem alterações mais recentes. Mudar para a última versão não verificada.

iMac G5 20" Model A1145 Hard Drive Replacement

Pré-requisito somente
Este guia destina-se apenas a ser usado como pré-requisito para outros guias. É incompleto por si só.

O que você precisa

  1. iMac G5 20" Model A1145 Hard Drive Replacement, Hard Drive: passo 1, imagem 1 %32
    • Disconnect the hard drive thermal sensor from the logic board by pulling its connector toward the top edge of your iMac.

  2. iMac G5 20" Model A1145 Hard Drive Replacement: passo 2, imagem 1 %32
    • Remove the two T10 Torx screws securing the hard drive bracket to the inverter.

  3. iMac G5 20" Model A1145 Hard Drive Replacement: passo 3, imagem 1 %32
    • Lift the left edge of the hard drive slightly, then pull it toward the left edge of the iMac.

    • When reinstalling your hard drive, make sure not to push the rubber grommets through the chassis with the hard drive mounting pins as retrieving them may require removing the logic board.

  4. iMac G5 20" Model A1145 Hard Drive Replacement: passo 4, imagem 1 %32
    • Rotate the hard drive out of the rear case.

    • Disconnect the SATA data cable by pulling its connector away from the hard drive.

  5. iMac G5 20" Model A1145 Hard Drive Replacement: passo 5, imagem 1 %32
    • Disconnect the SATA power cable by pulling its connector away from the hard drive.

    • Remove the hard drive from the iMac.

Conclusão

To reassemble your device, follow these instructions in reverse order.

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 598