Ir para o conteúdo principal

iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement

O que você precisa

  1. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement, Battery: passo 1, imagem 1 %32
    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  2. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: passo 2, imagem 1 %32
    • Lift the battery out of the computer.

  3. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement, Keyboard: passo 3, imagem 1 %32
    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again. The locking screw is in between the F5 and F6 keys and is a clear piece of plastic.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

  4. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: passo 4, imagem 1 %32
    • If the computer has an AirPort card installed, follow the next three steps to remove it.

    • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

  5. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: passo 5, imagem 1 %32
    • Grasp the clear plastic tab on the AirPort card and pull toward the display.

  6. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: passo 6, imagem 1 %32
    • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

  7. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: passo 7, imagem 1 %32
    • Remove the four silver Phillips screws that secure the RAM shield.

  8. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: passo 8, imagem 1 %32
    • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

  9. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: passo 9, imagem 1 %32
    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

    • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

Conclusão

To reassemble your device, follow these instructions in reverse order.

4 outras pessoas executaram este guia.

Documentos anexados

iRobot

Membro desde: 09/24/09

1 Reputação

Autoria de 636 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 2

Últimos 7 dias: 5

Últimos 30 dias: 12

Duração total: 12,216