Introdução

Replacing this keyboard is easy and takes only a few minutes.

  1. Use a coin to rotate the battery locking screw 90 degrees clockwise.
    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

    • Lift the battery out of the computer.

  2. Pull the keyboard release tabs (highlighted in red) toward you and lift up on the keyboard until it pops free.
    • Pull the keyboard release tabs (highlighted in red) toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

    • If your computer does not have an AirPort card installed, skip to the RAM shield removal step.

    • Push the wire clasp toward the AirPort card and pull it up to free it from the RAM shield.

    • Grasp the clear plastic tab on the AirPort card and pull toward the right.

    • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

    • Remove the two Phillips screws that secure the RAM shield.

    • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

Conclusão

To reassemble your device, follow these instructions in reverse order.

7 outras pessoas concluíram este guia.

Documentos anexados

iRobot

Member since: 24-09-2009

1 reputação

623 Guides authored

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 13

Todo: 7,190