Skip to main content
Help
Editando passo 3 —

Aviso: Você está editando um pré-requisito ao guia que você estava consultando. Quaisquer alterações que você faça afetarão todos os 24 guias que incluem este passo.

Tipo de Passo:

Arraste para reorganizar

Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case.

Take your time and apply firm, constant force. The display assembly is a much tighter fit than most devices and is held down with adhesive.

Pulling too hard may damage the display assembly. Apply just enough pressure to create a small gap between the display assembly and the rear case.

If you have any trouble, heat the front of the iPhone using an iOpener, hair dryer, or heat gun until it's slightly too hot to touch. This will help soften the adhesive securing the edges of the display.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.