Pular para o conteúdo principal
Ajuda
Editando passo 12 —

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão todos os 11 guias que incluem este passo.

Tipo de Passo:

Arraste para reorganizar

Remove the 4.8 mm standoff screw near the headphone jack.

Standoff screws are best removed using an iPhone Standoff Screwdriver Bit and driver handle.

In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

When reassembling the device, this standoff sets the height of the Wi-Fi shield removed in step 13. If not torqued down, the shield will be above the plane of the frame and the back will not slide into place in step 2. The shield should be flush with the headphone jack.

When reassembling the motherboard, ensure that its edge sits under the circled standoff, otherwise the screws will not fit.

When reassembling ensure that the small rubber spacer attached to the top of the motherboard is in place.

Without this part, the motherboard could damage the ribbon cables around it.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.