Ir para o conteúdo principal
Ajuda
Editando passo 4 —

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão todos os 5 guias que incluem este passo.

Tipo de Passo:

Arraste para reorganizar

Peel back the final battery adhesive tab from the bottom edge of the battery. Gently pull the battery adhesive tab upward and away from the battery, allowing the adhesive strip to slowly slide out from between the battery and the rear case.

Place one hand over the battery as the final strip comes out, or it may fling the battery out of the iPhone.

Continue pulling until the final strip comes free from the iPhone.

If you removed all three adhesive strips successfully, continue to step 24. Otherwise, if the adhesive breaks off underneath the battery and can't be retrieved, apply a few drops of high concentration (over 90%) isopropyl alcohol under the edge of the battery in the area of the broken adhesive strip(s).

Wait about one minute for the alcohol solution to weaken the adhesive. Use the flat end of a spudger to gently lift the battery.

Don't try to forcefully lever the battery out. If needed, apply a few more drops of alcohol to further weaken the adhesive. Never deform or puncture the battery with your pry tool.

Do not pry against the logic board, or you may permanently damage your iPhone. Do not pry under the topmost section of the battery, near the volume up button and mute switch, or you may damage the audio controls cable, which is adhered to the rear case just beneath the battery.

For alternative methods to unstick the battery, continue with the next step below.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.