Ir para o conteúdo principal
Ajuda
Editando passo 4 —

Aviso: Você está editando um pré-requisito ao guia que você estava consultando. Quaisquer alterações que você faça afetarão todos os 8 guias que incluem este passo.

Tipo de Passo:

Arraste para reorganizar

The battery press connector is attached to the underside of the display cable bracket on the screw hole side.

Insert the flat end of a spudger under the display cable bracket and lift up to disconnect the battery press connector from the logic board.

Take care to pry only under the edge of the connector to prevent damaging the socket itself and surrounding components.

To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage.

Don't try to remove the display cable bracket as it's attached to the battery by the battery cable.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.