Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Peças e ferramentas

Ajuda
Editando passo 2 —

Aviso: Você está editando um pré-requisito ao guia que você estava consultando. Quaisquer alterações que você faça afetarão todos os 6 guias que incluem este passo.

Tipo de Passo:

Arraste para reorganizar

Apply a suction cup to the right edge of the display as close as possible to the bottom of the device without overlapping the fingerprint sensor.

Pull up on the suction cup with firm, constant pressure to create a slight gap along the bottom edge between the screen assembly and rear case.

This may require a significant amount of force, but you only need to open a very slight gap with the suction cup to insert your tool.

As the display on top of the screen assembly is flexible, you may end up separating the right edge of the display from the screen assembly instead of lifting the entire assembly. Try to pull up just the bottom edge of the screen assembly to prevent warping the display.

If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools quickly, so you may need to heat it repeatedly.

Insert an opening pick into the gap you opened behind the screen assembly.

Ensure your tool is behind the entire screen assembly and not just the display. You should notice a small plastic tab unclip from the device's frame if you have done this correctly.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.