Pular para o conteúdo principal
Ajuda
Editando passo 1 —

Aviso: Você está editando um pré-requisito ao guia que você estava consultando. Quaisquer alterações que você faça afetarão todos os 6 guias que incluem este passo.

Tipo de Passo:

Arraste para reorganizar

Before starting this process it's important to note that the eMac can have some seriously dangerous voltages inside of it, thanks to the CRT display. Before working on an eMac, you should unplug it, press the power button to clear any stored charge on the motherboard, and then let it sit for 24-hours (or more) to allow the CRT to discharge.

You can read more about CRT safety procedures here. If you aren't experienced with working on devices featuring a CRT, it's recommended that you don't proceed any further.

On the bottom side of the eMac, remove the following screws:

A single 2.5mm hex screw

Two #2 phillips screws

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.