Pular para o conteúdo principal

Alterações no passo #2

Edição por Taylor Dixon

Edição aprovada por Taylor Dixon

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Place your hands at the top corners of the bezel (to the side) and lift the bezel 2-3cm from the body by working from the top. After this you can also disengage the bottom of the bezel (the memory modules will prevent the bottom of the bezel to detach first). When reassembling, start with the bottom of the bezel.
[* icon_caution] The top of the bezel hosts a microphone attached to the logic board. Gently lift the bezel to not damage the microphone wiring or connector by accidentally pulling the cable.
[* black] Decide to fullyicon_note] At this point, you can either detach the bezelmicrophone cable and remove the bezel, or to keep the microphone cable attached. In principle, there's enough play in the microphone wiring to allowattached and rest the bezel to lie flat aton your work surface or the topchassis of the chassisMac.
[* black] '''ForTo fully detachingdetach the bezel''': disconnect the microphone cable connector, removing tape as necessary.
[* black] '''Alternatively''', you may leaveTo keep it attached''', leave the microphone cable attached to the logic board. In this case,board, and place the bezel can be placed 'above' the chassis as ifchassis, with the microphone cable formsforming a hinge.
[* icon_caution] When deciding toIf you keep the microphone attached to the chassis, make sure you don't accidentally damage the microphone or logic board by bumping into the loose bezel.
[* icon_reminder] For the front bezel to sit properly, be sure to tuck the microphone cable and connector into the void next to the camera board.
[* icon_note] When reassembling the bezel, gently guide the microphone connector and cables through the ±1in long slot at the right of the iSight camera. Once the bezel is properly assembled, gently push the microphone connector and cable into the bezel through that slot.
[* black] Decide to fullyicon_note] At this point, you can either detach the bezelmicrophone cable and remove the bezel, or to keep the microphone cable attached. In principle, there's enough play in the microphone wiring to allowattached and rest the bezel to lie flat aton your work surface or the topchassis of the chassisMac.
[* black] '''ForTo fully detachingdetach the bezel''': disconnect the microphone cable connector, removing tape as necessary.
[* black] '''Alternatively''', you may leaveTo keep it attached''', leave the microphone cable attached to the logic board. In this case,board, and place the bezel can be placed 'above' the chassis as ifchassis, with the microphone cable formsforming a hinge.
[* icon_caution] When deciding toIf you keep the microphone attached to the chassis, make sure you don't accidentally damage the microphone or logic board by bumping into the loose bezel.
[* icon_reminder] For the front bezel to sit properly, be sure to tuck the microphone cable and connector into the void next to the camera board.
[* icon_note] When reassembling the bezel, gently guide the microphone connector and cables through the ±1in long slot at the right of the iSight camera. Once the bezel is properly assembled, gently push the microphone connector and cable into the bezel through that slot.

Imagem 2

Excluído

Imagem 3

Excluído