Ir para o conteúdo principal

Alterações neste passo

Edição por nicolay.94

Edição aprovada por nicolay.94

Antes
Depois
Sem alteração

Linhas de Passo

+[* black] Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case.
+[* black] Insert the flat end of a spudger into the gap.
+[* black] The watertight adhesive holding the display in place is very strong; creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, rock the screen up and down to weaken the adhesive until you can fit a spudger inside.
+[* black] While pulling up on the suction cup, twist the spudger to widen the opening between the screen and rear case.