Alterações no passo nº 3
Edição por Dayanna E. —
Edição aprovada por Dayanna E.
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Remove the circuit board from the front panel and screen, leaving the digitizer and circuit board intact. |
|---|---|
| - | [* black] Separate the existing, damaged glass from the front panel. |
| + | [* black] Next, remove the circuit board from the front panel and screen. This should leave the digitizer and circuit board intact. |
| + | [* black] Afterward, remove the existing damaged glass part of the device from the front panel as shown in the last picture. |
| + | [* black] Finally add a new STJR700 screen and reverse the previous steps to reattach the device. |