Alterações no passo nº 4
Edição por College Student —
Edição aprovada por College Student
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Heat the adhesive at the far end of the chip where the ribbon goes down into the device. Using the spudger, gently pry the chip off the board. Be careful not to melt the plastic edging during heating. (link to heat gun safety) |
|---|---|
| + | [* black] Heat the adhesive at the far end of the chip where the ribbon goes down into the device. Using the spudger, gently pry the chip off the board. Be careful not to melt the plastic edging during heating. |
| + | [* black] Heat gun safety: http://www.powertoolinstitute.com/pti_pdfs/PTI_Safety_heat_guns.pdf |