Ir para o conteúdo principal

Fix Your Stuff

Right to Repair

Parts & Tools

Alterações no passo #3

Edição por Nick

Edição aprovada de Nick

Excluído
Adicionado
Sem alteração

Linhas de Passo

[title] Remove the rubber bumpers
[* icon_reminder] These bumpers are held in with double sided tape. The tape will likely lose it's stickiness after one use, but it is not required to secure the drive bumpers.
[*
black] Once the drive is removed andfrom the drive clip is unscrewedclip, remove the rubber bumpers from the drivebumpers. To do this, pull them off of the drive as shownshown in the guide pictures. Transfer these to the new hard drive you are installing in the system.
[* icon_note] These
bumpers are held in with double sided tape. The tape will usually withstand 1-3 uses. After this you will need to either replace the tape on the drive bumpers or buy new onesyour replacement drive.
[* icon_reminder] These bumpers are held in with double sided tape. The tape will likely lose it's stickiness after one use, but it is not required to secure the drive bumpers.
[*
black] Once the drive is removed andfrom the drive clip is unscrewedclip, remove the rubber bumpers from the drivebumpers. To do this, pull them off of the drive as shownshown in the guide pictures. Transfer these to the new hard drive you are installing in the system.
[* icon_note] These
bumpers are held in with double sided tape. The tape will usually withstand 1-3 uses. After this you will need to either replace the tape on the drive bumpers or buy new onesyour replacement drive.