Conserte seus objetos Comunidade Loja

Alterações no passo nº 4

Edição por Marcos Serrano —

Edição aprovada por Marcos Serrano

Antes
Depois
Sem alteração

Linhas do passo

[* black] Lay the bottom part of the device upside down on a table.
[* red] Locate the four PH1 screw heads on the underside.
-[* black] In our guide, we used the IFIXIT pro tech toolkit. We used the bit driver with a 4mm driver attachment to elongate the driver. Then, attached the PH1 driver head to the 4mm driver. (See note below and second image)
+[* black] We used the bit driver with a 4mm driver(from IFIXIT pro tech toolkit) attachment to elongate the driver. Then, attached the PH1 driver head to the 4mm driver. (See note below and second image)
[* black] ***NOTE***: The PH1 screw heads are located 5cm into the device. Make sure to use a PH1 Driver that is 1cm in diameter and 5cm in depth.