Alterações no passo nº 4
Linhas do passo
| + | [* black] Lay the bottom part of the device upside down on a table. |
|---|---|
| + | [* red] Locate the four PH1 screw heads on the underside. |
| + | [* black] In our guide, we used the IFIXIT pro tech toolkit. We used the bit driver with a 4mm driver attachment to elongate the driver. Then, attached the PH1 driver head to the 4mm driver. (See note below and second image) |
| + | [* black] ***NOTE***: The PH1 screw heads are located 5cm into the device. Make sure to use a PH1 Driver that is 1cm in diameter and 5cm in depth. |
Imagem 1
Nenhuma imagem anterior
Adicionado
Imagem 2
Nenhuma imagem anterior
Adicionado
Imagem 3
Nenhuma imagem anterior
Adicionado