Alterações no passo nº 1
Edição por billyroypage —
Edição aprovada por billyroypage
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [* black] First replacing the door is challenging, but doable . Doors come in even sizes 30" , 32" 36" are standards . Bedrooms are usually 30 - 32" and are 1/38 thick. |
|---|---|
| + | [* black] yours may measure oddly depending on original conditions . But a replacement will be close to standard sizes. |
| + | [* black] Buying the new door . Your local Home Depot has a good selection of doors . You can buy a blank door (no prep) or a pre-fit door with the knob cut out and cut to size basically 3/16 under the original standard size this is the one I recommend if you don't have the tools to start from scratch. |
| + | [* black] Doors are right handed and left handed so just make sure the one you get (pre-fitted) has the knob on the correct side and is pre beveled. Only thing you "should" have to add is the new hinges. |
| + | [* black] Installation , remove the old door by driving the door pins up and out. Leave the jamb hinge half on for now. |
| + | [* black] remove the hinges from the old door and save them (important u save them) . Now a test run of new door without doing anything place the new door in the opening and see how it looks , if Alls well, we can add the hinges . Note: the knob may be off a little so you might have to adjust the strike on the jamb. |
Imagem 1
Nenhuma imagem anterior
Adicionado
Imagem 2
Nenhuma imagem anterior
Adicionado