Alterações no passo nº 7
Edição por Edward —
Edição aprovada por Andrew Optimus Goldheart
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Remove the following screws securing the logic board to the case: | |
| [* red] One 2.5 mm Phillips screw near the vibrator motor | |
| [* orange] One 2.4 mm Phillips screw | |
| [* yellow] One 3.6 mm standoff along the side of the logic board nearest the battery opening. | |
| - | [* icon_note] Use a [product|IF145-343|standoff driver bit|new_window=true] or a small flathead screwdriver to remove the single 3.6 mm |
| + | [* icon_note] Use a [product|IF145-343|standoff driver bit|new_window=true] or a small flathead screwdriver to remove the single 3.6 mm standoff screw. |