Conserte seus objetos Comunidade Loja

Alterações no passo nº 4

Edição por Matt Steensma —

Edição aprovada por Matt Steensma

Antes
Depois
Sem alteração

Linhas do passo

[* icon_reminder] Double check that all logic board connection on the top of the board have been disconnected.
[* black] Use a #00 Phillips screwdriver to remove the three, 3mm screws that secure the logic board to the device housing.
[* icon_note] One screw on this device is missing.
-[* red] Two large ribbons are still connected to the back of the logic board in the upper right corner. Lift the logic board up on the side with the 3.5mm headphone jack (closest to you). Remove the two ribbons on the back of the device by disconnecting the ZIF connections, pushing on the underside of the tabs.
+[* red] Two large ribbons are still connected to the back of the logic board in the upper right corner. Lift the logic board up on its side with the 3.5mm headphone jack facing you. Remove the two ribbons on the back of the device by disconnecting the ZIF connectors.