Pular para o conteúdo principal

Alterações no passo #3

Edição por Matt McCaffrey

Edição aprovada por Jake Devincenzi

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Use a plastic opening tool to pull the pressure contact from underneath the battery connector.
[* icon_caution] When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils on your fingers have the potential to create wireless interference.
[* icon_caution] Take notice of the position of the small black ground clip on the upper screw of the battery connector. This clip is attached only by the upper screw. When reinstalling, it must be aligned so the gold contact point will press against the back cover.
[* icon_caution] Take notice of the position of the small black ground clip on the upper screw of the battery connector. This clip is attached only by the upper screw. When reinstalling, it must be aligned so the gold contact point will press against the back cover.
[* black] Be '''VERY''' careful not to remove the pressure contact point from the logic board. There are 4 very small soldering points awaiting this mistake!