Pular para o conteúdo principal

Alterações no passo #3

Edição por Arthur Shi

Edição aprovada por Arthur Shi

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Use a plastic opening tool to pullgently detach the pressure contactbattery connector from underneath the battery connector.
[* icon_caution] When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils
socket on your fingers have the potential to create wireless interference.
[* icon_caution] Take notice of
device. Start lifting off the positionconnector from the bottom side, by placing the tip of the small black ground clip ontool between the loudspeaker enclosure and the upper screwmetal cover of the connector.
[* icon_note] The
battery connector. This clip is attached only byconnector comes off vertically from the upper screw. When reinstalling, it must be aligned so the gold contact point will press against the back cover.
[* black
logic board. Do not apply force sideways.
[* icon_caution
] Be careful not to rip off the battery connector socket soldered on the logic board. There are 4 very small soldering points awaiting this mistake!
[* black] Use a plastic opening tool to pullgently detach the pressure contactbattery connector from underneath the battery connector.
[* icon_caution] When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils
socket on your fingers have the potential to create wireless interference.
[* icon_caution] Take notice of
device. Start lifting off the positionconnector from the bottom side, by placing the tip of the small black ground clip ontool between the loudspeaker enclosure and the upper screwmetal cover of the connector.
[* icon_note] The
battery connector. This clip is attached only byconnector comes off vertically from the upper screw. When reinstalling, it must be aligned so the gold contact point will press against the back cover.
[* black
logic board. Do not apply force sideways.
[* icon_caution
] Be careful not to rip off the battery connector socket soldered on the logic board. There are 4 very small soldering points awaiting this mistake!

Imagem 1

Versão Antiga

Nova Versão

Imagem 2

Versão Antiga

Nova Versão

Imagem 3

Versão Antiga

Nova Versão