Pular para o conteúdo principal

Alterações no passo #1

Edição por John Schutz

Edição recusada por Geoff Wacker

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Remove the following screws securing the battery connector to the logic board:
[* red] One 1.7 mm Phillips screw
[* orange] One 1.5 mm Phillips screw.
[* black] Use a plastic opening tool to gently detach the battery connector from the socket on the device. Start lifting off the connector from the bottom side, by placing the tip of the tool between the loudspeaker enclosure and the metal cover of the connector.
[* icon_note] The battery connector comes off vertically from the logic board. Do not apply force sideways.
[*
icon_caution] Pay attention to the pressure contact underneath the top screw of the battery connector. This may come loose while pryingafter removing the battery connector from its sockettop screw.
[* icon_note] The pressure contact is a small black ground clip with a golden tip that presses against the back cover
.
[* black] Use a plastic opening tool to gently detach the battery connector from the socket on the device. Start lifting off the connector from the bottom side, by placing the tip of the tool between the loudspeaker enclosure and the metal cover of the connector.
[* icon_note] The battery connector comes off vertically from the logic board. Do not apply force sideways.
[*
icon_caution] Pay attention to the pressure contact underneath the top screw of the battery connector. This may come loose while pryingafter removing the battery connector from its sockettop screw.
[* icon_note] The pressure contact is a small black ground clip with a golden tip that presses against the back cover
.