Ir para o conteúdo principal

Alterações no passo #33

Edição por Phillip Takahashi

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

-[* black] Pour a small amount of plastic beads into a heat and stick resistant container.
+[* black] Pour a small amount of the plastic beads that were included with the kit into a heat- and stick-resistant container.
[* black] Use a heat gun to heat the plastic beads until they turn transparent.
- [* icon_note] Most hair driers are also capable of melting the beads. If neither a hair drier of sufficient power or a heat gun are available to you, you can also try boiling them and straining them out of the boiling water.
+ [* icon_note] Most hair driers are also capable of melting the beads. If neither a hair drier of sufficient power nor a heat gun are available to you, you can also try boiling them and straining them out of the boiling water.
[* black] When using a heat gun or hair dryer, be sure to turn the heat to high but leave the fan on low, or you will blow the beads out of the container!