Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #30

Edição por Phillip Takahashi —

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

[* black] Secure the PCB to the upper case half that had the old power supply unit using using the original 5.38 mm #1 Phillips screw and the included washer.
[* black] Secure the PCB to the upper case half that had the old power supply unit using using the original 5.38 mm #1 Phillips screw and the included washer.
[* icon_caution] Do not over-tighten the screw or you will break the screw hole.
[* icon_note] Be sure to orient the PCB so that it lines up with the indentation of the case and the voltage regulator is pointedpoints towards where the indentationgrey power inlet used to be.
[* icon_note] Be sure to orient the PCB so that it lines up with the indentation of the case and the voltage regulator is pointedpoints towards where the indentationgrey power inlet used to be.
[* black] Peel the backing off the heat sink.
[* black] Firmly press the heat sink onto the voltage regulator. Be sure the heat sink is shiftedset so that the corner pointing at the screwit lines up with the inside edge of the voltage regulatorregulator as seen in the third picture.
[* black] Firmly press the heat sink onto the voltage regulator. Be sure the heat sink is shiftedset so that the corner pointing at the screwit lines up with the inside edge of the voltage regulatorregulator as seen in the third picture.