Alterações no passo #30
Edição por Phillip Takahashi —
- Antes
- Depois
- Sem alteração
Linhas de Passo
| [* black] Secure the PCB to the case half that had the old power supply unit using the original screw and the included washer. |
| [* icon_caution] Do not over-tighten the screw or you will break the screw hole. |
| [* icon_note] Be sure to orient the PCB so that it lines up with the indentation of the case and the voltage regulator is pointed towards the indentation |
| [* black] Peel the backing off the heat sink. |
| [* black] Firmly press the heat sink onto the voltage regulator. Be sure the heat sink is shifted so that the corner pointing at the screw lines up with the voltage regulator. |
Imagem 1
Nenhuma imagem anterior
Adicionado
Imagem 2
Nenhuma imagem anterior
Adicionado
Imagem 3
Nenhuma imagem anterior
Adicionado