Ir para o conteúdo principal

Alterações no passo #14

Edição por Jake Devincenzi

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

-[* black] Insert the leads of the 240 Ω resistor through the holes indicated in step 7. This resistor will have a red, yellow, brown and gold band on it. The direction of the resistor does not matter.
- [* icon_note] Be sure to route the leads so that they do not cover any needed holes from step 7 or 8. Also, do not allow the leads to contact the leads of other components.
+[* black] Insert the leads of the 240 Ω resistor through the holes indicated in step 7. This resistor will have a red, yellow, brown, and gold band on it. The direction of the resistor does not matter.
+ [* icon_note] Be sure to route the leads so that they do not cover any needed holes from steps 7 and 8. Also, do not allow the leads to contact the leads of other components.
[* black] Solder the resistor to the PCB and clip the excess leads off.