Ir para o conteúdo principal

Alterações no passo #13

Edição por Phillip Takahashi

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

-[* black] Press the 240 Ω resistor through the holes indicated in step 9. Direction of the resistor does not matter.
-[* black] Solder the resistor into place and clip off the excess leads.
+[* black] Insert the leads of the 240 Ω resistor through the holes indicated in step 9. Direction of the resistor does not matter.
+ [* icon_note] Be sure to route the leads so that they do not cover any needed holes from step 9 or 10.
+[* black] Solder the resistor to the PCB and clip off the excess leads.