Ir para o conteúdo principal

Alterações no passo #12

Edição por Phillip Takahashi

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

[* black] Locate the oil dipstick. It has a yellow handle, is near the back center of the engine bay and is embossed with "Engine Oil".
[* black] Pull out the oil dipstick, wipe it off, place it all the way back into its hole and remove it again.
[* black] Check the oil level on the end of the dipstick. It should be between the two holes or slightly above the top one.
[* icon_note] This is not your actual oil level, but a pre-check to make sure the engine will not run dry when you first start it. The oil level will drop slightly after the first run when oil fills the new oil filter.
[* black] Add oil if the oil level is below the bottom hole of the dipstick. Place the oil dipstick all the way back in its hole.

Imagem 1

Nenhuma imagem anterior

Adicionado

Imagem 2

Nenhuma imagem anterior

Adicionado

Imagem 3

Nenhuma imagem anterior

Adicionado