Ir para o conteúdo principal

Alterações no passo #7

Edição por Phillip Takahashi

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

[* black] Wet the tip of a clean gloved finger with fresh oil and spread the oil around the new oil filter's seal.
[* black] Place the threaded end of the oil filter onto the engine's oil filter threads, being careful to not get dirt or debris on the filter's gasket.
[* black] Turn the filter clockwise by hand until it is snug.
[* icon_caution] If the filter is difficult to turn at the beginning of its threads, '''stop'''! You may be cross threading the oil filter. Re-align the oil filter and try again.
[* icon_caution] Do not over-tighten your oil filter by using a wrench. Doing so may cause the oil filter seal to leak and will make removing the oil filter very difficult in the future.
[* black] Remove the oil drain pan from underneath the truck.

Imagem 2

Nenhuma imagem anterior

Adicionado