Alterações no passo nº 7
Edição por Karl —
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Disconnect the trackpad and keyboard ribbon cable from the logic board, removing tape as necessary. | |
| - | [* icon_note] Note: It is possible to replace the hard drive without disconnecting the keyboard from the chassis, but it will need to be held upright to keep it out of the way, whilst allowing you both hands to work on the drive removal. |
| - | [* black] Remove the upper case. |
| + | [* icon_note] Note: It is possible to replace the hard drive without disconnecting the keyboard from the chassis, but it will need to be held upright to keep it out of the way, whilst allowing you both hands to work on the drive removal. Be careful when removing the keyboard-trackpad ribbon cable to ensure that the rear of the upper case is disengaged from the area near the hinge. It is easy to accidentally bend the screw receivers on either side of the keyboard. |
| + | [* black] Remove the upper case. |