Conserte seus objetos Comunidade Loja

Alterações no passo nº 6

Edição por Dayton —

Edição aprovada por Dayton

Antes
Depois
Sem alteração

Linhas do passo

-[* black] Lift and hold the upper pipe high enough to expose the plunger rod coupling.
-[* black] Place one open end wrench over the lower portion of the plunger rod coupling. Hold this wrench steady.
-[* black] Place another wrench on the upper portion of the plunger rod coupling. Turn this wrench counterclockwise until the coupling separates.
+[* black] Lift and hold the upper pipe high enough to expose the pump rod coupling.
+[* black] Place one open end wrench over the lower portion of the pump rod coupling. Hold this wrench steady.
+[* black] Place another wrench on the upper portion of the pump rod coupling. Turn this wrench counterclockwise until the coupling separates.
[* black] Pull the upper pipe away from the pump and lay it on its side away from the pump.
[* icon_note] Do not lay the pipe directly in grass or dirt, as you may get contaminants into the pipe that could obstruct water flow.