Ir para o conteúdo principal

Alterações no passo #2

Edição por Arthur Shi

Edição aprovada por Arthur Shi

Antes
Depois
Sem alteração

Linhas de Passo

[* black] Carefully placeApply a suction cup halfway up the heated side.
[* black] Carefully placeApply a suction cup halfway up the heated side.
[* black] Be sure the cup is completely flat on the screen to get a tight seal.
[* black] While holding the iPad down with one hand, pull up on the suction cup with strong, steady force to slightly separatecreate a gap.
[* icon_note] Depending on
the front panel assembly from from the rear case.
[*
age of your device, this may be difficult. If you have trouble, apply more heat and try again.
[*
icon_caution] Be careful to only lift the glass enough to insert an opening pick—any more and you risk cracking the glass.
[* black] While holding the iPad down with one hand, pull up on the suction cup with strong, steady force to slightly separatecreate a gap.
[* icon_note] Depending on
the front panel assembly from from the rear case.
[*
age of your device, this may be difficult. If you have trouble, apply more heat and try again.
[*
icon_caution] Be careful to only lift the glass enough to insert an opening pick—any more and you risk cracking the glass.