Ir para o conteúdo principal

Alterações no passo #6

Edição por Andrew Bookholt

Aguardando aprovação

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Very gently lift up the left side of the logic board.
[* icon_note] If the logic board does not immediately come free, it may be necessary to soften the thermal paste between the logic board and heat sink. You can soften the thermal compound using a hairdryer. Move the hairdryer back and forth between the two fans about one inch above the logic board for one minute. At this point, the logic board should now come free easily.
[* black] Lift the left edge of the board up to approximately a 30 degree angle (if you don't have your protractor handy, just lift until the DVI port clears the right hinge).
[* black] Once the logic board clears the ports, slide it out to the left.