Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #1

Edição por jonathanmorgan

Edição aprovada por Walter Galan

Antes
Depois
Sem alteração

Linhas de Passo

[* black] Remove the following screws securing the antenna plate to the mini:
[* red] Two 6.6 mm T8 Torx screws
[* orange] Two 5.0 mm T8 Torx or 2.0 mm Hex screws (either screwdriver will work)
[* black] When putting back together:
[* black] it can be difficult to get the hard drive seated correctly such that the antenna plate fits in place correctly. MakeIf the screw holes don't line up with those on the hard drive, make sure that the two pins that are in the back edge of the hard drive is close toare properly seated in the power supply on the right, and just a bit behindholes at the lipback of the case, above the housing for the second hard drive, beneath it, not tight against it or on top of it. It shoulddrive.
[* black] You might
be able to move a bit.
[* black] Then, seat
force the antenna plate, attachinto place if the pins aren't aligned, but you shouldn't have to if the pins are inserted correctly.
[* black] Because
the antenna plateattaches directly to the hard drive (red screws), then lockattaching the antenna plate into place (it has a small lip that latches overcan move the case at the back)hard drive around and screw inloosen the orange screwsconnection of the hard drive to the mother board. Double check that connection before continuing.
[* black] it can be difficult to get the hard drive seated correctly such that the antenna plate fits in place correctly. MakeIf the screw holes don't line up with those on the hard drive, make sure that the two pins that are in the back edge of the hard drive is close toare properly seated in the power supply on the right, and just a bit behindholes at the lipback of the case, above the housing for the second hard drive, beneath it, not tight against it or on top of it. It shoulddrive.
[* black] You might
be able to move a bit.
[* black] Then, seat
force the antenna plate, attachinto place if the pins aren't aligned, but you shouldn't have to if the pins are inserted correctly.
[* black] Because
the antenna plateattaches directly to the hard drive (red screws), then lockattaching the antenna plate into place (it has a small lip that latches overcan move the case at the back)hard drive around and screw inloosen the orange screwsconnection of the hard drive to the mother board. Double check that connection before continuing.